at91lib/boards, branch master

board/osmo-sdr: Add DFU support for the startup code

2012-03-29T08:40:00+00:00

DFU mode will be entered if: - 0xDFDFDFDF magic is at AT91C_IRAM - Button is pressed - No valid firmware seem to be present (start addr = 0xffffffff) Signed-off-by: Sylvain Munaut

SAM3U: Use correct DMAC peripheral ID for SSC receive

2012-02-26T21:00:35+00:00

It seems like the SSC Rx channel has a different DMAC peripheral ID (4) than the transmit side. The official Atmel sam3u documentation (doc6403e) doesn't document that fact, and it also doesn't even state any DMAC peripheral identifiers. The at91lib code release by Atmel claims it is 3, when in reality it is 4! I found this by brute-forcing all possible peripheral identifiers.

board/osmo-sdr: Add DFU support (like SAM3U-EK)

2012-01-08T17:32:36+00:00

add missing dfu.lds

2012-01-08T17:30:30+00:00

SAM3U-EK: Add a 'dfu' makefile target, DFU boot switching code

2012-01-08T16:14:16+00:00

DFU: add support for setting the USB SERIAL by a board

2012-01-08T10:52:15+00:00

this will allow us to use the Unique Chip ID as serial number in the USB descriptor, which in turn allows customers to write device-specific udev rules for persistent naming, etc.

aat91sam3u-ek: Add #defines for DFU

2012-01-05T21:16:33+00:00

osmo-sdr: only build flash images

2011-12-29T22:00:36+00:00

osmo-sdr: update GPIO definitions in board.h

2011-12-29T15:47:08+00:00

osmo-sdr/sam3u: add exidx sections to linker script

2011-12-28T00:18:29+00:00