1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
|
/* ----------------------------------------------------------------------------
* ATMEL Microcontroller Software Support
* ----------------------------------------------------------------------------
* Copyright (c) 2008, Atmel Corporation
*
* All rights reserved.
*
* Redistribution and use in source and binary forms, with or without
* modification, are permitted provided that the following conditions are met:
*
* - Redistributions of source code must retain the above copyright notice,
* this list of conditions and the disclaimer below.
*
* Atmel's name may not be used to endorse or promote products derived from
* this software without specific prior written permission.
*
* DISCLAIMER: THIS SOFTWARE IS PROVIDED BY ATMEL "AS IS" AND ANY EXPRESS OR
* IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF
* MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE AND NON-INFRINGEMENT ARE
* DISCLAIMED. IN NO EVENT SHALL ATMEL BE LIABLE FOR ANY DIRECT, INDIRECT,
* INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT
* LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA,
* OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF
* LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING
* NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE,
* EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
* ----------------------------------------------------------------------------
*/
//------------------------------------------------------------------------------
/// \unit
///
/// !Purpose
///
/// This module provides definitions and functions for using the Debug Unit
/// (DBGU).
///
/// It also overloads the fputc(), fputs() & putchar() functions so the printf()
/// method outputs its data on the DBGU. This behavior can be suppressed by
/// defining NOFPUT during compilation.
///
/// !Usage
///
/// -# Enable the DBGU pins (see pio & board.h).
/// -# Configure the DBGU using DBGU_Configure with the desired operating mode.
/// -# Send characters using DBGU_PutChar() or the printf() method.
/// -# Receive characters using DBGU_GetChar().
///
/// \note Unless specified, all the functions defined here operate synchronously;
/// i.e. they all wait the data is sent/received before returning.
//------------------------------------------------------------------------------
#ifndef DBGU_H
#define DBGU_H
//------------------------------------------------------------------------------
// Definitions
//------------------------------------------------------------------------------
/// Standard operating mode (asynchronous, 8bit, no parity, 1 stop bit)
#define DBGU_STANDARD AT91C_US_PAR_NONE
//------------------------------------------------------------------------------
// Global functions
//------------------------------------------------------------------------------
extern void DBGU_Configure(
unsigned int mode,
unsigned int baudrate,
unsigned int mck);
extern unsigned char DBGU_GetChar(void);
extern void DBGU_PutChar(unsigned char c);
extern unsigned int DBGU_IsRxReady(void);
#endif //#ifndef DBGU_H
|
